2 Flex the sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper.
Straighten the edges on a level surface.
3 Reload paper into the multipurpose feeder.
Note: Make sure the paper guide lightly rests against the edge of the paper.
4 From the printer control panel, press to clear the message and continue printing.
200 paper jams
200 paper jam messages
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to
“Sensor (input) static jam service check”
on page 95.
200.02 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 95.
200.03 Page did not reach input sensor or was late
reaching input sensor, but was successfully
picked from the source.
Go to
“Sensor (input) early/late arriving service
check” on page 95.
200.05 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 95.
200.08 Page arrive at input senor at unexpected time. Go to
“Sensor (input) early/late arriving service
check” on page 95.
200.09 Printhead did not receive proper motor feedback
to start laser servo.
Go to
“Sensor (input) jam service check” on
page 97.
200.10 Printhead motor not locked when media reaches
the input sensor.
Go to
“Sensor (input) jam service check” on
page 97.
200.11 Printhead motor fell out of lock after page reaches
the input sensor.
Go to
“Sensor (input) jam service check” on
page 97.
4514-2xx
Diagnostics and troubleshooting
93
To Next Page
Loading...
