Available options:
• 1
• 2
Set Network Card Speed
Note: This setting appears only on models that support a network connection.
This determines whether the printer automatically detects or manually detects the network speed.
Available options:
• Auto—The network card attempts to detect the speed and duplex mode value of the network.
Note: A user may have to assign
specific
values to these settings since Auto may not function correctly in
some network environments.
• 10Mbps, half duplex—Forces the printer to try to connect to the network only at 10 Mbps, half duplex
• 10Mbps, full duplex—Forces the printer to try to connect to the network only at 10 Mbps, full duplex
• 100Mbps, half duplex—Forces the printer to try to connect to the network only at 100 Mbps, half duplex
• 100Mbps, full duplex—Forces the printer to try to connect to the network only at 100 Mbps, full duplex
Entering Invalid engine mode
This mode is used if the printer has an invalid code and needs the correct code loaded. After entering this
mode, the firmware code can be updated.
1 Turn o the printer.
2 Press and hold and .
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Entering Recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer.
Code can be flashed from a PC using a USB connection.
1 Turn o the printer.
2 Press and hold .
3 Turn on the printer.
4 Release the button after 10 seconds.
4514-2xx
Service menus
168
To Next Page
Loading...
