Lexmark MS310 4514-220 - 202 Paper Jams

Action Yes No
Step 3
Check the redrive rollers for damage.
Are they free of damage?
Go to step 4. Replace the redrive
assembly. See
“Redrive assembly
removal” on
page 259.
Step 4
Does the error remain?
Contact the next
level of support.
The problem is
solved.
202 paper jams
202 paper jam messages
Error code Description Action
202.01 Exit sensor is covered during warm up. Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.03 Media did not reach the fuser exit sensor. Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.05 Exit sensor covered too long or exit sensor did not
clear ahead of a sheet.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.13 Restart attempted after an internal jam without
cover open. Close event. Likely that the jam was
not actually cleared.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.14 Expected banner sheet ( assumed wide ) not
detected by narrow media sensor, possible
accordion jam, unsupported narrow banner
media, or missing signal.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.16 Page at fuser nip before fuser started ramping
toward desired. Indicates code may be receiving
more hall interrupts than intended.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.17 Page at fuser nip before fuser reached acceptable
operating temperature. Page arrived at fuser
earlier than expected, so it was probably staged.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.22 Cartridge Motor - Motor Underspeed Error. Motor
made it to closed loop steady state, but then
detected speed was below threshold.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.28 Exit sensor bounce issue. Go to
“Sensor (fuser exit) jam service check” on
page 100.
202.32 The sheet is too long to be duplexed. The blow
through is enabled.
Go to
“Duplex service check” on page 101.
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
Go to
“Duplex service check” on page 101.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
Go to
“Sensor (fuser exit) jam service check” on
page 100.
4514-2xx
Diagnostics and troubleshooting
99