Chapter 21 Appendix A: Operation Commands
151
Syntax: delete performance
Explanation: delete E1 performance data
Parameters: none
Command: >release bert
Syntax: release bert
Explanation: release E1 bert
Parameters: none
Command: >release loopback
Syntax: release loopback
Explanation: release E1 loopback
Parameters: none
Command: >release pattern
Syntax: release pattern
Explanation: release E1 pattern function
Parameters: none
Command: >set e1 frame
Syntax: set e1 frame framing_mode
Explanation: Set E1 line farming mode. When none is selected, E1 is used as clear channel.
Parameters: mode: FAS/none
Command: >set e1 code
Syntax: set e1 code coding_mode
Explanation: Set E1 line coding mode
Parameters: mode AMI/HDB3
Command: >set e1 crc
Syntax: set e1 crc setting
Explanation: Loop-IP6610 can be used in two frame or multiframe mode. For two frame, set CRC (Cycle
Redundancy Check) to OFF. For multiframe mode, set CRC to ON. A proprietary facility
data link is implemented in both modes to facilitate remote system control and performance
and statistics monitoring. When the E-Bit is set to ON, it enables the use of the E bits in the
CRC - 4 multiframe alignment signal for the automatic reporting of a CRC error from the
remote side.
Parameters: setting on/off
Command: >set e1
Syntax: set e1 idle_code
Explanation: Any DS0 channel, which is not assigned to a WAN port, is an idle channel. An idle code is
transmitted on idle DS0 channels. Users may program the idle channel to any bit pattern
from 00H to FFH.
NOTE: Due to the ones-density requirement, it is advised that idle code be set
as 0xD5. Or, the user must program the idle code to contain at least
two bits of '1'. The factory default idle code is 0xD5.
Parameters: value 0x00~0xff