EHGBWBIE
Page
€42
are clean, then fit new bearing shells. Apply a small amount of 'Cylesso'
(or
graphogen grease) to the bearing shells.
*Oversize refers to the outside dimension of the bearing
shell.
4.
Ensure that the crankshaft main journals are clean, then fit the crankshaft.
Spin the crankshaft to ensure even distribution of the 'Cylesso'
.
Fit new
selective thrustwashen to the rear main bearing so that the oil grooves (the
'copper' side) are towards the crankshaft. Check
the end-flwt between the
crankshaft and the thrustwashers (see TECHNICAL DATA).
If
the end-flwt
is
outside this tolerance, replace the selective thrust washers.
5.
Apply 'Silastic' to shoulder or1 the spray shield. With the step of the shield
facing towards the rear of the cylinder block, slide over the crankshaft
between flywheel flange and rear of block. Turn the shield until it
is
flush
with the block
on the
RH
side from flywheel end. Push shield into
its
location at rear of cylinder block (see illustration.
..
.
ESPRIT'
Issue
on178
Fig.
26
Location of spray shield
m
To Next Page
Loading...
