To Next Page

To Previous Page

7.2.1 Communication Line Connection

7.2.2 Setting Communication Parameters

7.2.3 Setting Operation Command and Frequency

7.2.4 Command Loss Protective Operation

7.2.5 Setting Virtual Multi-Function Input

7.2.6 Saving Parameters Defined by Communication

7.2.7 Total Memory Map for Communication

7.2.8 Parameter Group for Data Transmission

7.3 Communication Protocol

7.3.1 LS INV 485 Protocol

7.3.2 Modbus-RTU Protocol

7.4 DriveView9

7.5 Compatible Common Area Parameter

7.6 G100 Expansion Common Area Parameter

7.6.1 Monitoring Area Parameter (Read Only)

7.6.2 Control Area Parameter (Read/ Write)

7.6.3 Memory Control Area Parameter (Read and Write)

8 Table of Functions

8.1 Operation Group

8.2 Drive Group (PAR→dr)

8.3 Basic Function Group (PAR→bA)

8.4 Expanded Function Group (PAR→Ad)

8.5 Control Function Group (PAR→Cn)

8.6 Input Terminal Block Function Group (PAR→In)

8.7 Output Terminal Block Function Group (PAR→OU)

8.8 Communication Function Group (PAR→CM)

8.9 Application Function Group (PAR→AP)

8.10 Protection Function Group (PAR→Pr)

8.11 2nd Motor Function Group (PAR→M2)

9 Troubleshooting

9.1 Trip and Warning

LSIS G100 User Manual

Other manuals for LSIS G100