command with the keypad [RUN] key
3.4 Monitoring the Operation
3.4.1 Output Current Monitoring
3.4.2 Trip Condition Monitor
4 Learning Basic Features
4.1 Frequency Reference Configuration
4.1.1 Set the Operation Frequency from the Keypad - Direct Input
4.1.2 Set the Operation Frequency from the Keypad - Using [▲] and [▼]
keys
4.1.3 V1 Terminal as the Source
4.1.4 Built-in Volume Input (V0) as the Source
4.1.5 Setting a Reference Frequency using Input Current (I2)
4.1.6 Frequency Reference Source Configuration for RS-485
Communication
4.2 Frequency Hold by Analog Input
4.3 Multi-step Frequency Configuration
4.4 Command Source Configuration
4.4.1 The Keypad as a Command Input Device
4.4.2 Terminal Block as a Command Input Device (Fwd/Rev Run
Commands)
4.4.3 Terminal Block as a Command Input Device (Run and Rotation
Direction Commands)
4.4.4 RS-485 Communication as a Command Input Device
4.5 Forward or Reverse Run Prevention
4.6 Power-on Run
4.7 Reset and Restart
4.8 Setting Acceleration and Deceleration Times
4.8.1 Acc/Dec Time Based on Maximum Frequency
4.8.2 Acc/Dec Time Based on Operation Frequency
4.8.3 Multi-step Acc/Dec Time Configuration
4.8.4 Acc/Dec Time Switch Frequency
4.9 Acc/Dec Pattern Configuration
4.10 Stopping the Acc/Dec Operation
4.11 V/F Control
To Next Page
Loading...
