LB 9507 Chapter 7: Quantitative Measurements (LIA...)
7-19
BACKGROUND TOO HIGH !
This display only appears when the background threshold you
have defined in the protocol is exceeded. If this happens printout
of measurement values is flagged BKG.
The steps which the instrument goes through are displayed, and
the measurement parameters from the active protocol are printed
out at the same time.
L61
INJECTING ...
L62
MEASURING ...
L63
SAMPLE-RLU 133
REMOVE TUBE
The first line shows the result of the measurement in RLUs, the
second line (if defined in the protocol) the result of a background
measurement. At the same time the measured RLU result is
printed out for each tube (for replicates the mean value and the
coefficient of variation of the respective replicate group are printed
out too).
L64
TOTAL REPL. # 1 TUBE # 2
INSERT TUBE ...
Position the 2nd tube in the measurement series. The following
display appears:
L64a
TOTAL REPL. # 1 TUBE # 2
START
To Next Page
Loading...