LB 9507 Chapter 5: Raw Data Measurements
5-13
R31
BACKGROUND TOO HIGH !
This display only appears when the background threshold you
have defined in the protocol is exceeded. If this happens the
printout of measurement values is flagged BKG.
The steps which the instrument goes through are displayed and
the measurement parameters from the active protocol are printed
out at the same time.
R32
INJECTING ...
R33
MEASURING...
R34
SAMPLE-RLU 133
REMOVE TUBE
Once measurement is complete, the first line shows the result of
the measurement in RLUs, the second line (if defined in the
protocol) shows the result of the background measurement. At the
same time the measurement parameters defined in the protocol
are printed out as a protocol header.
The measured values are then printed:
Measured values output:
No kinetics curve, no replicates selected:
One measured value per sample (RLU)
No kinetics curve, but replicates:
One measured value per sample (RLU)
Average for replicate group and coefficient of variation
To Next Page
Loading...