Driving
5.2 Operating the transmission
Operating Manual GMK6300L 3 112 xxx en 5 - 27
xx.xx.xxxx
5.2 Operating the transmission
The transmission automatically controls all gear changes. However, gears
can be changed manually at any time.
5.2.1 Switching on
•
Switch on the ignition.
– The electronic transmission system is switched on and a test program
runs. At the same time, the displays (1) and (2) light up in the
Transmission
display.
– If a gear is engaged when the ignition is switched off, the transmission
switches into the neutral position. The entry NN appears in the
Transmission display.
– The
Transmission display shows the current state, e.g. neutral position
If an error occurs, which may be of importance for continued driving,
the corresponding symbols appear on the displays (1), (2);
à p. 7 - 39.
G
Risk posed by unexpected rolling!
When the ignition is switched on, the transmission switches to the neutral
position N.
Therefore always apply the parking brake or the service brake before you
switch on the ignition.
This prevents the truck crane from suddenly rolling away.
1 on the Transmission display
2 on the
Driving display
To Next Page
Loading...
