Crane operation
11.6 Work break
11 - 130 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
11.6.2 In case of work breaks of more than 8 hours
• Retract all telescopic sections.
• Set down the main boom on the boom rest.
• Switch off the slewing gear.
– The lamp in the (1) button must be dimly lit.
– Lamp (2) must light up – slewing gear brake applied.
• Switch the engine off, turn the ignition key to position 0 and remove it.
• Switch off all current consumers.
• Switch off the battery master switch. This will not interrupt the run-down
period of the heater.
To secure the
truck crane
• Secure the truck crane against unauthorised use by:
– stowing the hand-held control in the crane cab,
– removing the ignition key and
– locking the crane cab.
G
Danger due to unauthorised use!
Always lock the hand-held controller before you leave the truck crane. In
this way you can prevent unauthorised persons from starting the engine
with the hand-held control.
To Next Page
Loading...
