Starting/switching off the engine – for crane operation
10.1 Starting the engine – from the crane cab
10 - 8 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
Checking the
hand-held control
The hand-held control must be removed for crane operation from the crane
cab.
• Check whether the bridging plugs (1) are
inserted in all the sockets;
à p. 12 - 21.
You can start the engine from the crane cab,
but if the hand-held control is connected, the
operating elements for crane operation are
disabled.
10.1.5 Switch on the ignition
•
Insert the ignition key into the ignition lock and turn the key to position 1.
After switching on the ignition, a lamp test is performed and switching
states are aligned.
To Next Page
Loading...
Need help?
General
