Malfunctions during crane operation
14.5 Emergency operations and programs
Operating Manual GMK6300L 3 112 xxx en 14 - 57
xx.xx.xxxx
14.5.3 Entering the current telescoping
ECOS no longer displays the current telescoping,
– if you telescoped in emergency mode, or
– if the power supply was interrupted in the course of saving data.
In these cases, you must enter the current telescoping, e.g. the values from
the RCL display.
• If necessary, open the main menu ö and press the button (1) once.
This opens the
Settings submenu.
Entering target values
The display (8) shows the values for telescopic
sections I to VI.
• Press one of the buttons (1) to (6) – the
values in the display (8) turn yellow.
Each time you press a button, the correspond-
ing value in the display (8) switches continu-
ously between the fixed lengths and the
symbol (9) for
Unlocked.
• Enter the desired set values for all the tele-
scopic sections, e.g. unlocked, 100%, 100%,
100%, 100%, 100%.
You can cancel the entry at any time using
button (7).
s
To Next Page
Loading...
Need help?
General
