Driving with a rigged truck crane
13.6 Driving in combined operation
13 - 10 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
13.6 Driving in combined operation
With additional equipment, you can drive the truck crane from the driver's
cab while the engine for the crane operation is running.
• Before driving, observe the specifications in sections 13.1 to 13.2.
13.6.1 Switching combined operation on/off
Prerequisites – The rigging mode for driving with or without load is set correctly;
à p. 13 - 2.
– The hand-held control has been disconnected and bridging plugs have
been plugged into all superstructure and carrier sockets.
In the driver's cab
– The parking brake must be applied.
– The ignition key is in position 1.
In the crane cab
– The superstructure ignition has been switched on for approx. 30 seconds.
G
Risk of accidents when driving with a lifted load!
The truck crane may only be moved without a load in combined operation.
Always set the load down before you move the truck crane.
To Next Page
Loading...
