Manitowoc Grove GMK6300L-1

Driving modes
6.5 Installing/removing outrigger beams
Operating Manual GMK6300L 3 112 xxx en 6 - 57
xx.xx.xxxx
6.5.7 Unscrewing/screwing in the spacers
There are two spacers for each outrigger beam
– In the supporting box
– In the outrigger beam on the opposite side.
The illustrations show as an example the spacers for the outrigger beams
on the front right hand side.
Unscrewing Before you pull out the outrigger beams, you must unscrew the spacers.
At the supporting box
• Undo the wheel nuts (2).
• Unscrew the bolts (1) until the spacers (3)
are screwed into the supporting box (4)
completely.
At the outrigger beam
• Undo the wheel nuts (2).
• Unscrew the bolts (1) until the spacers (3)
are screwed into the outrigger beam (4)
completely.
s