Rigging work
12.5 Starting the engine for driving for rigging work
12 - 26 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
12.5.2 Starting/switching off the engine from the outrigger control
units
Prerequisites The following requirements must be met before you can start the engine for
driving from the outrigger control units:
– The ignition in the driver's cab must be switched on.
– The ignition in the crane cab must be switched off.
– The lamp in the button (1) lights up.
Starting the
engine
All activities and checks required to start the engine must be carried out
before starting the engine; à p. 4 - 1.
• Press the button (3) once – the engine will start.
Switch the engine
off
• Press the button (1) once – the engine will switch off.
To Next Page
Loading...
