Driving with a rigged truck crane
13.3 Before driving
13 - 6 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
Horizontally aligning the truck crane
• Press the (1) button until the selected axles
touch the ground.
• Repeat the procedure on the other axles
until an even axle load is indicated on the
display (2).
If required, you will have to lower or raise the
lowered axles again to achieve an even axle
load.
To secure the truck crane
• Retract the outrigger cylinders until the outrigger pads are about 5 to
10 cm (2 to 4 in) above the ground. Leave the outrigger beams extended.
S
Risk of damage to the tyres and suspension struts!
Do not exceed the maximum permissible axle load of 32 t when levelling
the truck crane.
Monitor the display while levelling and adjust the axle loads as necessary!
G
Danger of overturning if outriggers are retracted!
Always leave the outrigger beams extended and the outrigger pads just
above the ground to secure the truck crane against overturning.
To Next Page
Loading...
Need help?
General
