Manitowoc GROVE GMK7450 - Page 128

Maintenance work on the carrier
7.8 Axle lines
7 - 56 3 302 577 en Maintenance manual
GMK7450
16.08.2018
1st and 5th axle
line
• Remove the drain plug (1).
• Check that the oil reaches the lower edge of
the openings.
• Fit new gaskets and tighten the screws.
If the oil level is too low
• Top up with oil; à P. 7 - 58.
2nd and 4th axle
line
The drive has two oil chambers.
• Remove the drain plugs (1) and (2).
• Check that the oil reaches the lower edge of
the openings.
• Fit new gaskets and tighten the screws.
If the oil level is too low
• Top up with oil; à P. 7 - 58.