METREL MI 2893 User Manual

MI 2893 / MI 2892 / MI 2885 Abbreviations
18
Part 4-15: Testing and measurement techniques – Flicker
meter – Functional and design specifications
IEC 62053-21: 2020
Electricity metering equipment (a.c.) - Particular requirements
- Part 21: Static meters for active energy (classes 1 and 2)
IEC 62053-23: 2020
Electricity metering equipment (a.c.) - Particular requirements
- Part 23: Static meters for reactive energy (classes 2 and 3)
IEEE 1459: 2010
IEEE Standard Definitions for the Measurement of Electric
Power Quantities Under Sinusoidal, Non-sinusoidal, Balanced,
or Unbalanced Conditions
EN 50160: 2010
Voltage characteristics of electricity supplied by public
electricity networks
GOST R 54149: 2010
Electric energy. Electromagnetic compatibility of technical
equipment. Power quality limits in the public power supply
systems
Note about EN and IEC standards:
Text of this manual contains references to European standards. All standards of EN 6XXXX (e.g. EN
61010) series are equivalent to IEC standards with the same number (e.g. IEC 61010) and differ only in
amended parts required by European harmonization procedure.
1.4 Abbreviations
In this document following symbols and abbreviations are used:
CF
I
Current crest factor, including CF
Ip
(phase p current crest factor) and
CF
IN
(neutral current crest factor). See 5.1.3 for definition.
CF
U
Voltage crest factor, including CF
Upg
(phase p to phase g voltage
crest factor) and CF
Up
(phase p to neutral voltage crest factor). See
5.1.2 for definition.
 DPF
ind/cap
Instantaneous phase power displacement (fundamental) power
factor or cos , including  DPFp
ind
(phase p power displacement).
Minus sign indicates generated power and plus sign indicates
consumed power. Suffix ind/cap represents inductive/capacitive
character.
DPF
ind/cap

Recorded phase displacement (fundamental) power factor or cos ,
including DPFp
ind/cap

(phase p power displacement).
Minus sign indicates generated
power and plus sign indicates
consumed power. Suffix ind/cap
represents inductive/ capacitive
character. This parameter is recorded
separately for each quadrant as
shown on figure. See 5.1.5 for
definition.
 DPFa
totind
 DPFa
totcap
Instantaneous total arithmetic displacement (fundamental) power
factor.
Minus sign indicates generated power and plus sign indicates
consumed power. Suffix ind/cap represents inductive/capacitive
character. See 5.1.6 for definition.
270
0
DPFind+
Lead
Lag
DPFcap+
DPFcap-
DPFind-
180
0
90
0
0
0
+P-P
-Q
+Q
I
II
III IV

METREL MI 2893 Specifications

General

Brand	METREL
Model	MI 2893
Category	Measuring Instruments
Language	English