Microplex SOLID F90 HD - Page 134

134 Troubleshooting
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
Error code
[Pap.at Sep.Sec.! ]
[E0011 ]
[Paper at Fuser! ]
[E0012 ]
[Paper at Output! ]
[E0013 ]
[Abnorm.PaperPos.! ]
[E0016 ]
[No Clean. Unit! ]
[E0026 ]
[WasteTon.BoxFull! ]
[E0028 ]
[No Waste Ton.Box! ]
[E0029 ]
[No Toner! ]
[E002A
]
[Toner Low ]
[E002D ]
[Rear Cover Open! ]
[E0033 ]
Description
There is still paper within the separator unit.
Remove the paper (see section 8.3).
There is still
paper within the fuser unit.
Remove the paper (see section 8.3).
There is still paper within the exit unit.
Remove the paper (see section 8.3).
Paper jam within the feeding unit.
Remove the jammed paper (see section 8.3) and
press the key SPLIT.
The cleaning unit is missing.
Install the cleaning unit.
The waste toner bottle is full.
Replace the bottle with a new one (see section 3.3).
There is no waste toner bottle within the unit.
Insert a wa
ste toner bottle (see section 3.3).
There is no more toner within the cartridge.
Insert a new toner cartridge (see section 3.2).
The message [Toner Low ] is only a warning that the printer
will run out of toner soon. Replace the toner cartridge as soon
as the message [No Toner ] is displayed (see section 3.2).
The rear cover has not been closed completely.
Please close it completely.