Troubleshooting 135
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
Error code
[Stacking Fail.! ]
[E0055 ]
[Stacker Full! ]
[E0056 ]
[Stacker Not Rdy! ]
[E0057 ]
[Stack.Limit Err.! ]
[E0059 ]
Description
Hint:
[E005 at the beginning of the error code indicates
stacker error messages:
Fanfold paper is not folded correctly.
Check whether paper is set correctly or not.
The power stacker is full.
Please remove the paper.
Stacker is not ready
Stacker capacity is exceeded.
Please remove the paper.
More error messages a
re listed in section 8.2.1.
!
If the remedies above are not successful, please call a MICROPLEX
authorized service engineer.
When reporting a problem to your service engineer, please give him
the precise error message. That helps to localize the error more
quickly.
To Next Page
Loading...
