Microplex SOLID F90 HD - Page 137

Troubleshooting 137
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
Error code
[No Pre Charger! ]
[E001B ]
[Flash Failure! ]
[E001F
]
[Fuser Overheat! ]
[E0020 ]
[Dev.Motor Fail.! ]
[E0022 ]
[Dev.UnitSetIncor.! ]
[E0023 ]
[Clean.U.SetIncor.! ]
[E0024
]
[No Clean. Unit! ]
[E0026 ]
[WasteTon.BoxFull! ]
[E0028 ]
[No Waste Ton.Box! ]
[E0029 ]
[No Toner! ]
[E002A
]
[Toner Low ]
[E002D
]
[LED Array Overh.! ]
[E0032 ]
Description
Pre charger is missing
Flash is missing
Fuser unit is too hot
Developer motor does not work normally
Developer unit setting is not correct
Cleaning unit setting is not correct
Cleaning unit is missing
Waste toner bottle is full
Waste toner bottle is missing
No toner
Toner density is not normal (too low)
LED head is too hot