MIMAKI JV33-260 - Page 102

3-30
Setting of Tension Bar Position
Set the operating position of the tension bar for the heavy duty take-up device while drawing.
1
Press the key in the local mode.
2
Select [MACHINE SETUP] by pressing the keys.
3
Press the key.
4
Select [Feeding / TakeUP] by pressing the keys.
5
Press the key.
6
Select [TensionBar-POS.] by pressing the keys.
7
Press the key.
8
Select the set value by pressing the keys.
9
Press the key.
10
Press the key several times to end.
• When changing the setting, be sure to understand the setting contents referring to P.2-18 “Setting the
active position of the take-up tension-bar” before change it.
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP < ENT >
MACH I NE S E TUP
DEODOR I Z E F AN < e n t >
MACH I NE S E TUP
Feed i ng / TakeUP <en t >
Feed i ng / TakeUP
UN I T SE L ECT < e n t >
Feed i ng / TakeUP
TensionBar-POS.<ent>
Feed i ng / TakeUP
Tens i onBa r -POS. : LOW