MIMAKI JV33-260 - Warning Messages

6-7
Warning / Error Messages
1
2
3
4
5
6
Troubleshooting
Message Cause Solution
Ink near end was detected right
after the cartridge with much
remaining amount of ink has been
inserted.
Pull out the inserted cartridge and insert it
again. If the message will be displayed
again, contact a distributor in your district
or our office to call for service.
There is a problem with installed ink
cartridges.
(In the case of overlapping with
other warnings, the display turns to
"< LOCAL.1> !CAR/WASH" and
[#**] is erased. )
Check the content of the warning details in
the guidance function.
There is a problem with the installed
cleaning solution cartridge.
(In the case of overlapping with
other warnings, the display turns to
"< LOCAL.1> !CAR/WASH" and
[#**] is erased. )
Check that the cleaning solution cartridge
has been set properly.
The ink of the ink cartridge has
been nearly used up.
Replace the cartridge generating the
warning with a new one.
The ink of the ink cartridge has
been completely used up.
Replace the cartridge generating the
warning with a new one.
The ink cartridge is not MIMAKI
genuine.
Replace the cartridge generating the
warning with a MIMAKI genuine.
The IC chip of the ink cartridge
cannot be read normally.
Remove the cartridge generating the
warning once and install it again.
If the same warning message still
appears, contact your local distributor to
call for service.
The ink of the ink cartridge is
different in type from the ink
currently supplied.
Check the ink type of the cartridge
generating the warning.。
The ink of the ink cartridge is
different in color from the ink
currently supplied.
Check the ink color of the cartridge
generating the warning.
There is trouble with an installed ink
cartridge.
Check the cartridge generating the
warning.
An ink cartridge has not been
installed in the slot.
Install an appropriate cartridge in the slot
generating the warning.
The specified expiration date of an
ink cartridge has passed.
Replace the cartridge generating the
warning with a new one.
The cartridge may be used until one
month passes after the specified
expiration date.
The expiration date of an ink
cartridge has passed (one month
has passed after the specified
expiration date).
The red LED blinks. Replace the cartridge
generating the warning with a new one.
The cartridge may be used until two
months pass after the specified expiration
date.
<LOCAL. 1> [ #01 ]
RE I NSERT CARTR I DGE
<LOCAL . 1> !CAR
[#01]
*REMOTE. 1* !CAR
[#01]
<LOCAL . 1> !WASH
[#01]
*REMOTE. 1* !WASH
[#01]
INK NEAR END
MMCC ----
INK END
---- YYKK
NON-ORIGINAL INK
---- YYKK
WR O N G I N K I C
---- YYKK
Kind of INK
---- ----
Co l o r o f I NK
---- ----
WR O N G C A R T R I D G E
---- ----
NO CARTR I DGE
---- ----
Exp i r a t i on
---- ----
Exp i r a t i on : 1MONTH
---- ----