MIMAKI JV33-260 - Prior to Pump Tube Washing

5-8
Prior to Pump tube washing
Prior to washing of the pump tube, it is required that the cleaning solution has been filled within the tube.
Filling Cleaning solution
1
Select [HD.MAINTENANCE] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [HD.MAINTENANCE] by pressing the keys.
(4) Press the key.
2
Select [MaintWashLiquid] by pressing the
keys.
3
Press the key.
4
Press the key.
• Proceed to the step 6 when a normal cartridge has been set.
5
Set a cleaning solution cartridge.
6
Press the key.
• Filling of the cleaning solution is started.
• When the following messages are indicated, check the waste ink tank, and then operate it, referring to
P.5-37 “If Waste ink tank confirming message is displayed” according to the situation.
Con f i rm a was t e tan k
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange :
e nt
HD . MA I NTENANCE
MaintWashLiquid<ent>
MaintWashLiquid
FILLING UP <ent>
MaintWashLiquid
CARTRIDGE : none
When "END" is indicated :
The cleaning solution is not left. Replace
it with a new cleaning solution cartridge.
When an abnormal condition is
indicated :
The cartridge that has been set is not a
cleaning solution cartridge.
MaintWashLiquid
FILLING UP START:
e nt