5-3
Maintaining
1
2
3
4
5
Routine Maintenance
Cleaning exterior surfaces
If exterior surfaces of the machine is stained, dampen a
soft cloth with water or a neutral detergent diluted with
water, squeeze it and wipe the surfaces with the cloth.
Cleaning the platen
On the platen, it is easy to become dirt due to lint, paper
dust or the like caused by cutting medias.
For a conspicuous stain, wipe it off with a soft-hair brush,
a dry cloth, a paper towel or the like.
Cleaning of after heater cover and pre heater cover
The after heater cover and the pre heater cover are easy to be dirty because of the powder of the medium etc. If
it shows dirt, wipe it with a soft cloth soaked in water or waterish mild detergent and wrung.
• If it is stained with ink, wipe it off with a
paper towel containing a little amount of the
cleaning solution.
• Before starting to clean the platen, make sure that the platen has cooled adequately.
• Be sure to clean the slot for media pressing, the slot for paper cutting (the cutter line) or the like since
dust and dirt are easily accumulated in these parts.
After heater cover Pre heater cover
To Next Page
Loading...
