MIMAKI JV33-260 - Setting a Narrow Roll Media

2-20
Setting a narrow roll media
1
Fix the tension-bars on the front and the back of this
machine at the lock position.
• The locks are on the right front and the left back of this machine.
• Lift the tension-bars and fix them with the locks
2
Set “OFF” on [UNIT SELECT] of [Feeding/TakeUP] in MACHINE SETUP. ( P.3-29)
3
Move the roll holder on the back of this machine.
• Loosen the roll holder fixing screw and then move it.
• Move the roll holder to set the media in the center of this
machine.
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll media on the
let roll holder.
• Push the roll media onto the roll holder until the roll core is all
the way seated.
6
Loosen the screw of the right side roll holder then
insert the holder into the core of the roll media.
7
Raise the clamp lever in the front of this machine.
• Set the media with less than 1.6m wide on the narrow roll holder.
• Grip the outside of the lock of the tension-bar.
If gripping the other parts, your hand may get stuck in.
Roll holder
Roll holder
fixing screw
Clamp lever