MIMAKI JV33-260 - Stopping the Print Temporarily; Erasing the Received Data (Data Clear)

2-41
Drawing data
1
2
Basic Operations
5
6
Stopping the print temporarily
Perform the following operations when stopping the print halfway.
1
Press the key in printing.
• The printing operation is interrupted.
• Interrupt data sending at the PC side during the data is sent from the
PC.
• Printing restarts from the interrupted data by repressing the
key.
Erasing the received data (Data clear)
Erase only the received data to stop the printing.
1
Press the key in the local mode.
2
Press the key.
• The ACTIVE lamp goes out.
• The received data is erased then it returns to the local mode.
<LOCAL . 1> [ #01 ]
width:1272mm
DATA CLEAR
<ENT>
** DATA CLEAR **