2-37
Head Cleaning
1
2
Basic Operations
5
6
Perform head cleaning depending on the test printing result
There are three types of head cleaning. Use one by checking the test pattern.
1
In the local mode,
press the key.
2
Select the cleaning type by pressing the keys.
NORMAL : Select this if any line is missing.
SOFT : When only head wiping is desirable. (in case of bent lines)
HARD : Select this if inferior printing cannot be improved even by [NORMAL] or [SOFT] cleaning.
3
Press the key.
• The rest of the cleaning time is indicated at the lower of the display.
• On completion of cleaning, this machine returns to LOCAL mode.
4
Perform test printing again, and check the result.
• Repeat the cleaning and the test printing until the drawing result becomes in normal.
Perform spot color maintenance
Perform this to solve color heterogeneity due to settling down of pigment when using silver ink or white ink of ES3
ink.
Spot color maintenance is selectable only when silver ink or white ink of ES3 ink has been filled for the firmware
Ver.4.60 and later.
1
In the local mode,
press the key.
2
Press the keys to select [spot].
3
Press the key.
When the image quality is not improved after the head cleaning.
•Clean the wiper and ink cap. ( P.5-5)
•Wash the head nozzle. ( P.5-10)
•Solve the failure of the image quality, referring to "When Nozzle clogged after cleaning".
(P.5-18)
CLEAN I NG ACT I VE
00 : 00
SPOT COLOR SELECT
COLOR : S I L VER
To Next Page
Loading...
