Pre-heater
Preheats the media before printing.
(Located inside the platen)
Heavy-duty feeding device
Set a heavy roll medium when drawing with a heavy
roll medium (the medium width is 1.6m or more).
AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever in the font
of this machine.
USB 2.0 connector
This is USB2.0 interface connector.
Main power switch
Turns on/off the main power for this machine. Leave
the main power turned on to prevent ink clogging.
Cleaning solution
cartridge
Set a dedicated Washings
cartridge (optional).
Roll holders
Putting this into the paper core (right
and left) of a narrow roll medium
(less than 1.6m), hold the medium.
It supports the paper core of 2 inch
and 3 inch.
To Next Page
Loading...
