MIMAKI JV33-260 - Operation Panel

1-6
Operation Panel
Use the operation panel to make settings for printing or operate this machine.
Functions of the JOG keys
Each of the JOG keys varies in function according to the condition of the machine under which the key is used.
The functions of the JOG keys are as follows:
Before the detection of
media
After the detection of
media
When selecting a
function
When selecting a
setting value
Detects the width of the
media.
Shifts the carriage to the
left.
Detects the width and
length of the media.
Shifts the carriage to the
right.
Moves the media inward.
Returns to the previously
indicated function again.
Selects the previously
indicated value again.
Moves the media
frontward.
Goes to the next function. Selects the next value.
JOG key
Use these keys to shift the carriage or the media in
[LOCAL mode]. Also use them to select an item of
printing conditions.
key
Use this key to display function setting menu.
key
Cancels the last input value or returns the setting menu to
the immediate higher level of the hierarchy.
Display
Displays the status of the machine,
set items and errors.
ACTIVE lamp
Blinks in receiving or
drawing data.
key
Use this key to switch between [REMOTE mode] and
[LOCAL mode].
key
Registers the last input value as the setting value or goes to
the immediate lower level of the hierarchy.
key
Use this key on Station maintenance.
key
Draws test patterns to check if there are any drawing
failures such as ink clogging.
key
Use this key to set the temperatures of the Pre-heater,
Print heater and Post-heater or check the current
temperature of the platen.
key
Selects User type.
key
Executes Head cleaning at ink
clogging.
key
Deletes the data that have been
received.
CONSTANT lamp
Lights in green when the heater temperature reaches
the set temperature.
HEAT lamp
Lights in orange during heating up of the heater.