MIMAKI JV33-260 - Adjusting Suitable Temperature Adjustment (When Solvent Ink Is Used)

3-10
Adjusting suitable temperature adjustment (When solvent ink is used)
This section describes the procedure for setting the heater temperatures properly.
The proper heater temperatures depend on the media type and ambient temperature. Set temperatures that are
appropriate to the media. For non-coated media or media on which ink is slow to dry, set the heater temperatures
so that the ink fixing and drying characteristics will be improved.
Wait until the CONSTANT lamps light up.
Set the heater temperatures ( P.3-8)
Correct the media feed rate ( P.3-5)
Yes
No
Is media wrinkled?
Test printing
Does media stick to platen?
Does beading occur?
END
Lower the heater
temperatures
Raise the heater
temperatures
Move the media back
and forth with [ ^ ] and [
v ] keys.
Initially, set higher
temperatures
No
No
Yes
Yes