MIMAKI JV33-260 - Cutting a Media

Drawing data
2-42
Cutting a media
For a roll media, two ways are available to cut the media after printing is completed, as follows.
Auto cut
A media is automatically cut after printing is completed.
1
Cut the media automatically after printing is
completed.
Manual cut
Cut the media at an optional position by using the keys on the operation panel.
1
Press the keys
in the local mode.
• It enters the printing origin setting mode.
• Feed the media to the position to cut by pressing the key.
2
Press the key.
3
Press the key.
• This machine cuts the media.
• It returns to the local mode after cutting is completed.
• Pay attention so that printed surface does not touch to a floor or other printed surfaces when the media
is cut.
• When the take-up device is used, roll up the cut media by operating a switch of the take-up device.
• For the Auto cut function, it is required to set. (The Auto cut function is set to “OFF" when purchased.)
• When using the narrow take-up device, take up a cut medium using the switch of the take-up device.
• When using the tension bar of the heavy medium take-up device, the cut function cannot be used
because of safety.
OR I G I N SE TUP
0.0 ----
MED I A CU T
<ENT>
MED I A CU T T I NG
PLEASE WA I T