1-10
Connecting cables
Connecting USB2.0 interface cable
Connect the PC and this machine with the USB2.0 interface
cable.
Notes on USB 2.0 Interface
When two or more JV33 machines are connected to one personal computer
When two or more JV33 machines are connected to one personal computer, the personal computer may not
recognize all the JV33 machines normally.
Reconnect the unrecognized JV33 machine to another USB port, if available, and check to see if it is recog-
nized. If the JV33 machine is not recognized by the newly connected USB port, use USB 2.0 repeater cables
available on the market.
Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is con-nected to
the same personal computer that a JV33 machine is connected to, the USB device may not be recognized.
When a JV33 printer is connected to the personal computer to an externally installed USB hard disk drive , the
data output speed to the JV33 machine may drop. That can cause the head unit to stop temporarily at the right or
left end during printing.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached
to the PC.
• Your RIP must be compatible with USB 2.0.
To Next Page
Loading...
