2-40
Drawing data
Starting the print
1
Set the media. ( P.2-6)
2
Check the heater temperatures.
• Confirm that the CONSTANT lamp lights in [PRE], [PRINT],
[POST] below the display.
3
Press the key in the local mode.
• It enters the remote mode and enables to receive the data from the
PC.
4
Send the drawing data from the PC.
• The ACTIVE lamp blinks and the drawing condition is
displayed.
• For the method of data transmission, refer to the instruction
manual for the output software.
5
This machine starts printing.
• The printing speed may vary due to the set media width or the
position of print origin even when the same data is printed,
depending on resolution.
• When a roll media is used, rewind the roll media by hands prior to printing so that it is set in the tightened
condition. The loosened may result in failures of the image quality.
TEMPERATURE CONTROL !
PLEASE WA I T
*REMOTE. 1* 720x720
16 .Bd .Vd . x2 xx . xxm
Resolution : 360 /540 /720 /
1440 DPI
Number of passes
The length of
media drawn
Scan direction
Ud : Unidirectional
Bd : Bidirectional
Data type
Vd : Variable data
Nd : Normal data
Scanning speed
x1 : Standard
speed
x2 : Double
speed
To Next Page
Loading...
