MIMAKI JV33-260 - Other Settings

3-24
Other settings
Change the setting according to the use.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing the keys then press the key.
4
Select an item for setting by pressing the keys.
• Select it, referring to the list of settings.
5
Press the key.
6
Select the set value by pressing the keys.
• Select it, referring to the list of settings.
7
Press the key.
8
Press the key several times to end.
List of Settings
The underlined has been set when purchased.
• The set value is maintained even when the power is tuned “OFF”.
Item Outline Set value
Setting of Media compensation Corrects the feeding rate of media Refer to P.3-5
Setting of Heater Setting Heater temperature Refer to P.3-8
Setting Heater standby time and OFF time
Setting of Printing mode Setting Print quality Refer to P.3-12
Setting Scanning direction
Setting Logical-seek
Setting WhiteLay Print
Setting of the number of ink
layers
Setting the number of layers in which ink is
to be applied.
1
~ 9
Setting of Drying time Setting the time for drying ink every
scanning.
Refer to P.3-17
Setting the time for drying ink after the
completion of printing.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1