MIMAKI JV33-260 - Setting medias

2-6
Setting medias
This machine can be used with roll media and leaf sheet media.
For usable medias, refer to P.1-15 “Usable sizes of media”.
Adjusting the head height
Adjust the head height according to the thickness of the media used.
1
Move the carriage to the platen.
• When the device is turned on :
Execute [ST.MAINTENANCE] - [CARRIAGE OUT] ( P.5-5
Step1,2)
• When the device is turned off :
Open the front cover, then move the carriage by hand.
2
Loosen two screws located at the front.
• Loosen the screws, rotating by one turn with a screwdriver.
3
Adjust the height-adjusting lever according to the
media.
• Adjust the position of the lever, referring to "For the adjusting
lever and the range".
• Set the height-adjusting lever to the highest stage or the
lowest stage. Setting it to the intermediate height, a printing
fault can result.
• Adjust the head height prior to setting of the media. If the head height is adjusted after the media is set,
this may cause media jamming, deterioration of the drawing quality or head damage.
• The range of the initial head height is adjustable by 2 levels according to the purpose of use.
• The range of the printing height of JV33 is from the general printing (L range: 2 mm/3 mm) to the
transfer printing (H range: 4 mm/5 mm) (Set to L range 2 mm at shipping)
• If the drawing quality is set to "Bi-D" ( P.3-14) , perform "DROP POSITION" of the maintenance
function after the head height is adjusted. ( P.5-23)
Carriage
Screw
Height-adjusting lever