MIMAKI JV33-260 - Confirming the Heater Temperature

Preparing Heaters
2-31
1
2
Basic Operations
5
6
Reference for the temperature set (When solvent ink is used)
Confirming the Heater temperature
1
Press the key on the operation panel.
• The current Heater temperature is displayed.
2
Press the key at the end of confirmation.
• It returns to the local mode.
Type of ink
ES3 ink SS21 ink
Type of media
Glossy
chloroethylene
Tarpaulin FF All medias
Set of the Pre-heater
40°C 40°C 40°C 35°C
Set of the Print-heater
40°C 40°C 40°C 35°C
Set of the Post-heater
50°C 50°C 50°C 50°C
• Adjust it to suitable temperature depending on the media condition.
• When aqueos-color ink is used, no reference for the temperature set is required.
PRE PRT POST
35°C 40°C 50°C