MIMAKI JV33-260 - Setting Whitelay Print

Setting print mode
3-16
Setting WhiteLay Print
When using SS21 white ink, you can print with other colors after printing with white ink, without returning the
media.
In this page, set the printing method of white ink and other color ink.
1
Perform operations up to P.3-12 the step 5.
2
Select [WhiteLay Prt] by pressing the keys.
3
Press the key.
4
Select set value by pressing the keys.
• Set value : OFF, ON (LEVEL 1 ~ 3)
5
Press the key.
6
Press the key several times to end.
Set Value Outline
OFF
Printing the white ink and the color ink at the same time.
ON (LEVEL1~3
*1
)
*1. This machine cannot set the order of synthesis.
Printing the color ink on the white ink after printing with the white ink.
• If a larger number is set for LEVEL 1 to 3, time interval between printing
with white ink and printing with color ink becomes long.
• If a large number is set for LEVEL, drying property of white ink goes up,
but printing time becomes long.
• This function can be set only when SS21 ink (6 colors + white) is filled.
• Printing time is about two times longer than normal printing.
• When printing on the following condition, as usable number of nozzles is limited, printing speed slows.
Setting of printing
quality
Resolution Printing width
DRAFT 540 x 1080 dpi
1541 mm or above
FINE
720 x 1080 dpi
1155 mm or above
720 x 1440 dpi
1440 x 1440 dpi
1155 mm or above (577mm for Vd data)
[1]PRINT MODE
DRAF T QUAL I TY < e n t >
[1]PRINT MODE
Wh i t eLay Pr t <en t >
[1]Whi teLay Prt
SEL . :
OFF
[1]Whi teLay Prt
SEL . : ON ( LEVEL3 )
[1]PRINT MODE
Wh i t eLay Pr t <en t >