To use sublimation transfer ink with more stable quality
3-45
1
2
3
Convenient use
5
6
Set the interval to display the warning message
Depending on the ambient temperature, set the interval to display the warning preventing color material settling.
1
Select [ROUTINE SETUP] of the maintenance menu.
(1) Press the key in LOCAL.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [ROUTINE SETUP].
(4) Press the key.
2
Press to select [Sub-INK WARNING].
3
Press the key.
4
Press to set the operation time.
• Set value : OFF (disabled) or 12 to 120 hours
5
Press the key.
6
Press the key several times to end the setting.
Note on head height adjustment
When you use sublimation transfer ink Sb52, if you make the head height 5mm (H range/ thick), it may affect the
drawing quality.
It is recommended to use with making head height 4mm (H range/ thin) or L range.
• When you use sublimation transfer ink Sb52, the display interval of the message is set to 72 hours in
the initial condition.
• When you use sublimation transfer ink Sb51 or Sb60, this function is disabled (OFF) in the initial
condition.
• If the head height is 5mm, the right message may be displayed at
starting of drawing or at turning on the power supply.
When you press the key, the message goes out.
• You can check the current head height with the procedures below:
(1) Press the key in LOCAL.
(2) Press the key several times to display “Head height” and then check.
“HEAD HEIGHT :Thin” = The head height is 2mm.
“HEAD HEIGHT :Thick” = The head height is 3mm.
“HEAD HEIGHT :Thin+” = The head height is 4mm.
“HEAD HEIGHT :Thick+” = The head height is 5mm.
• For the head height adjustment method, refer to P.2-6 “Adjusting the head height”.
• Contact to our sales office for switching L range <-> H range by field person.
ROUT I NE SETUP
Sub - INK WARN I NG<en t >
ROUT I NE SETUP
Sub - INK WARN I NG=
7 2h
ROUT I NE SETUP
Sub - INK WARN I NG=
8 4h
ROUT I NE SETUP
Sub - INK WARN I NG<en t >
NOT RECOMMENDED ! !
CHK . HEAD HE I GHT : e n t
To Next Page
Loading...
