2-28
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and deciding the position.
When the heavy-duty feeding / take-up device is not used
1
In the local mode,
press the keys.
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by pressing the
keys.
• Select the carriage and media, moving the point with the
keys.
3
After determining the origin,
press the key.
• The printing origin is changed.
• The origin position set above misaligns with the feeding direction of a media by a few centimeters. Turn
[FEED ORIGIN] “ON” in setup mode to fit the origin to the correct light position of LED pointer.
(P.3-4)
OR I G I N SE TUP
0.0 ----
OR I G I N SE TUP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SE TUP
** ORIGIN **
To Next Page
Loading...
Need help?
General
