Setting medias
2-29
1
2
Basic Operations
5
6
When the heavy-duty feeding / take-up device is used
1
In the local mode, press the
keys.
• It enters into the origin setting mode.
2
Press the keys to determine the moving direction of the origin.
• To move to the front of the current origin : Press the .
To move to the back of the current origin : Press the .
3
Press the keys again to determine the origin of the feeding direction.
• Press the same keys as the keys determined on Step 2. If different key is pressed, only the
moving direction of the origin changes without changing the origin.
4
Press the keys to determine the origin of the width direction.
5
After determining the origin, press the
key.
• The origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned at about 75 mm rearward from the slot for cutting on the
platen. The printing origin in the scanning direction (Y') is positioned at 25 mm from the right end of the media. The
value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION mode.( P.3-3)
This can be changed by using the Jog key.
OR I G I N SE TUP
0.0 ----
FEED D I RECT I ON SET
[BACK FEED]
FEED D I RECT ION SET
[FORE FEED]
Move the origin to the front Move the origin to the back
OR I G I N SETu p : BACK
0.0 ----
OR I G I N SE T u p : FORE
0.0 ----
Move the origin to the front Move the origin to the back
OR I G I N SE TUP
** ORIGIN **
slot for cutting
approx. 75 mm
(X’)
25 mm
(Y’)
To Next Page
Loading...
