MIMAKI JV33-260 - Setting Media Detection

3-23
1
2
3
Convenient use
5
6
Setting media detection
Set the method for detecting a media when the media is set and the detecting type when the media is cut.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing the keys then press the key.
4
Select [MEDIA DETECT] by pressing the keys.
5
Press the key twice.
• The setting display for the media detection is displayed.
6
Select the set value by pressing the keys.
SELECT : Select either a roll media or leaf media by pressing the keys when the media is
detected.
WIDTH : The width of media is only detected without any key input when the media is
detected.(Detecting is started automatically by lowering the clamp lever.)
7
Press the key.
8
Select [CUTTING DETECT] by pressing the key.
9
Press the key.
10
Select the set value by pressing the keys.
• Set value : BOTH EDGE / LEFT EDGE / RIGHT EDGE / NONE
11
Press the key.
12
Press the key several times to end.
• If the set value is set to others than “BOTH EDGE” in [CUTTING DETECT], although the cutting time is
shortened, cutting remainders may happen due to the media skew.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
MED I A DE T EC T < e n t >
[1]MEDIA DETECT
DETECT METHOD :
SELECT
[1]MEDIA DETECT
DETECT METHOD <e n t >
[1]MEDIA DETECT
CUT T I NG DETECT < e n t >
[1]MEDIA DETECT
DETECT :
BOTH EDGE