xi
Precautions in Use
CAUTION
Power supply Handling of ink
• Leave the breaker turned ON.
• Do not turn off the main power switch on the right
side of this machine.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least 15
minutes. In doing so, also wash eyes to rinse ink
away completely. Then, consult a doctor as soon
as possible.
• If anyone drinks ink by mistake, keep him or her
quiet and see a doctor immediately. Do not allow
him or her to swallow the vomit. After that,
contact the Poison Control Center.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air and
then keep yourself warm and quiet. Then, consult
a doctor as soon as possible.
• The ink contains organic solvent. If ink settles on
the skin or clothes, immediately wash it off with
detergent and water.(only when solvent is used)
Heater
• Do not spill liquid on the platen as this may cause
failure of the heater or firing.
• Do not touch platen heaters with bare hand while
it is hot; otherwise, you can get burned.
• When the machine is to be moved, wait until the
heater temperature drops adequately.
As a criterion, wait at least 30 minutes after you
turn off the power to the heater.
Moving the machine must be limited to on the
same floor where there is no steps. When the
machine is to be moved to any place other than
on the same step-free floor, contact your
distributor or a sales office of MIMAKI.
Note on maintenance
• When cleaning the ink-station or the heads, make sure to wear the attached gloves.
Further, when the solvent ink is used, it is necessary to wear the attached goggles.
To Next Page
Loading...
Need help?
General
