MIMAKI JV33-260 - Perform Setting of Feeding and Take up

3-29
Machine settings
1
2
3
Convenient use
5
6
Perform setting of feeding and take up
For the setting of feeding and take up, there are “Setting of UNIT SELECT” which is used to set whether the
heavy medium take-up device/the heavy medium feeding device is used or not and “ which is used to set the
operating position of the tension bar for the heavy medium feeding device.
Setting of UNIT SELECT
This is used to set whether the heavy duty take-up device/the heavy-duty feeding device is used or not.
1
Press the key in the local mode.
2
Select [MACHINE SETUP] by pressing the keys.
3
Press the key.
4
Select [Feeding / TakeUP] by pressing the keys.
5
Press the key.
6
Press the key.
7
Press the keys to change the setting.
Item selecting : by the keys
Unit setting : by the keys
8
Press the key.
• If you perform setting of the tension bar continuously, operate the procedures from Step 6 of “Setting of
Tension Bar Position”.
9
Press the key several times to end.
• For setting of UNIT SELECT, when you set “OFF” to the heavy duty take-up device/the heavy -duty
feeding device, be sure to fix tension bars of each device at the lock position before performing setting.
Especially, if the tension bar for the take-up device is not locked, the take up setting cannot be switched
to “OFF”.
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP < ENT >
MACH I NE S E TUP
DEODOR I Z E F AN < e n t >
MACH I NE S E TUP
Feed i ng / TakeUP <en t >
Feed i ng / TakeUP
UN I T SE L ECT < e n t >
FEED I NG : TAKE - UP
ON ON