MIMAKI JV33-260 - Error Messages

6-10
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message Cause Solution
An error occurred in the circuit board
system. (ROM)
Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
An error occurred in the circuit board
system. (RAM)
An error occurred in the circuit board
system. (POWER +5V)
An error occurred in the circuit board
system. (POWER +24V)
An error occurred in the circuit board
system. (POWER +42V)
An error occurred in the circuit board
system. (F-ROM)
An error occurred in the circuit board
system. (SD-RAM)
An error in heads was detected.
(Abnormal temperature was detected.)
An error in heads was detected.
(Abnormal voltage was detected.)
An error occurred in the linear encoder.
(Counting was unable. )
An error occurred in the linear encoder.
(Error in the mounting direction.)
An error occurred in the linear encoder.
(Read-out count error)
An error occurred in the circuit board
system.
(FPGA PDC)
An error occurred in the circuit board
system.
(FPGA HDC)
The machine received some data other
than command data.
Securely connect the interface cable in
position.
Use an interface cable conforming to
the specifications.
An error occurred when the machine
cannot print on front side.
Check the machine.
When ON is set for back side printing,
the machine received some data other
than back side printing data.
Check the setting of the printing data
again.
***** ERROR 01 *****
MA I N ROM
***** ERROR 02 *****
MA I N RAM
***** ERROR 03 *****
POWER + 5 V
***** ERROR 03 *****
POWER + 2 4 V
***** ERROR 03 *****
POWER + 4 2 V
***** ERROR 04 *****
F-ROM
***** ERROR 06 *****
SD - RAM
***** ERROR 07 *****
HEAD (----)
***** ERROR 07 *****
VOLTAGE (----)
***** ERROR 08 *****
L i n e a r ENCODER : SENSOR
***** ERROR 08 *****
L i nearENCODER
:
DIR.
***** ERROR 08 *****
L i n e a r ENCODER : COUNT
***** ERROR 09 *****
FPGA ERROR
***** ERROR 09 *****
HDC ERROR (----)
***** ERROR 10 *****
COMMAND ERROR
***** ERROR 10 *****
CMD ( DB L . S i d e : FRON T )