MIMAKI JV33-260 - Setting Cleaning While Printing

3-22
Setting cleaning while printing
Set it whether the head cleaning is carried out automatically during printing or not.
Upon cleaning during printing, set the cleaning interval to the length printed.
The printing is interrupted each in the set length and the head cleaning is carried out automatically.
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing the keys then press the key.
4
Select [Print.CLEANING] by pressing the keys.
5
Press the key.
6
Select “ON” by pressing the keys.
• Proceed to the step 9 when “OFF” is selected.
7
Press the key.
8
Set an interval of cleaning and cleaning type by pressing
the keys.
Item selecting : by the keys
Interval and Type setting : by the keys
9
Press the key.
10
Press the key several times to end.
• This function does not operate when ink near-end occurs. Solve the ink near-end, referring to P.1-12.
• Depending on the conditions of the heads, etc., the defective printing could not be recovered even
performing this function. In this case, contact our service office or distributor.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
Pr int .CLEANING <ent>
[1]Pr i nt .CLEANIN
SETUP :
OFF
[1]Pr i nt .CLEANIN
SETUP :
ON
INTERVAL :TYPE
1 000mm :NORMAL
INTERVAL :TYPE
1 000mm :NORMAL
Interval :
10 to 10000mm
Type : NORMAL
SOFT
HARD