MIMAKI JV33-260 - Discharge & Wash

5-19
When Nozzle clogged after cleaning
1
2
3
4
5
Routine Maintenance
DISCHARGE & WASH
Discharge ink from the heads, dampers and ink tubes, and then wash them.
1
Select [HD.MAINTENANCE] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [HD.MAINTENANCE] by pressing the keys.
(4) Press the key.
2
Select [DISCHARGE&WASH] by pressing the
keys.
3
Press the key.
4
Remove the ink cartridge.
• The ink left in the head or tube is discharged to the waste ink tank.
• The display on the right is displayed after discharging.
5
Set the cleaning solution cartridge to the ink station.
• Absorbing of the cleaning solution is started.
• The display on the right is displayed after absorbing.
6
Remove the cleaning solution cartridge.
• The ink left in the head or tube is discharged to the waste ink tank.
• The right display on the right is displayed after discharging.
• To use this function, the dedicated cleaning solution ( P.5-2"Notes on cleaning solution") is required.
In addition, before performing the work, check whether ink to be filled again remains or not.
• When the following messages are indicated, check the waste ink tank, and then operate it, referring to
P.5-37 “If Waste ink tank confirming message is displayed” according to the situation.
Con f i rm a was t e tan k
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange :
e nt
HD . MA I NTENANCE
DISCHARGE&WASH <ent>
Remove : InkCar t r i dges
MMCC YYKK
*DISCHARGE*
00 : 00
Set :WashingCartr idge
1234 5678
*ABSOPRPTION*
00 : 00
Remo v e : Ca r t r i dge s
1234 5678
*DISCHARGE*
00 : 00
Set :WashingCartr idge
1234 5678