MIMAKI JV33-260 - Setting Print Mode; Setting of the Print Quality

3-12
Setting print mode
Upon the setting of the print mode, set each item for printing as follows.
• Print quality (DRAFT) : Setting the print quality in the DRAFT mode (Resolution in the scanning direction:
540dpi)
• Print quality (FINE) : Setting the print quality in the FINE mode (Resolution in the scanning direction: 720dpi)
• Scanning direction : Setting the printing direction
• Logical-seek : Setting "ON/OFF" of Logical-seek
• WhiteLay Print : Setting the way of print with other colors after printing with SS21 white ink
Setting of the print quality
1
Press the key in the local mode.
2
Press the key.
3
Select the type (1-4) by pressing the keys
then press the key.
4
Select [PRINT MODE] by pressing the keys.
5
Press the key.
6
Select an item to be set.
(1) Select [DRAFT QUALITY] or [FINE QUALITY]([DRAFT QUALITY] is selected here.) by pressing
the keys.
(2) Press the key.
7
Select the print quality by pressing the keys.
• Set value : STD / FAST / FINE
• Press the key to terminate the setting at this then proceed to the step10.
8
When changing the details of printing quality at each resolution.
Select the resolution by pressing the key.
• Set value : 540x720, 540x900, 540x1080 dpi (When “DRAFT” is selected)
720x540,720x720,720x1080,720x1440 dpi (When “FINE” is selected)
(1) Select the resolution by pressing the key.
(2) Press the key.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
PR I NT MODE < e n t >
[1]PRINT MODE
DRAF T QUAL I TY < e n t >
[1]PRINT MODE
DRAF T q u a l i t y :
S TD .
[1]DRAFT QUALITY
540x720 <en t >