3-3
User type
1
2
3
Convenient use
5
6
List of functions
This section describes the outline of each SET UP function registerable to the user type and the setting value.
The underlined has been set when purchased.
Function name Set value Outline
MEDIA COMP. ( P.3-5) -255 ~ 0 ~ 255 Prints a pattern to correct the
feeding rate of media and corrects it.
HEATER
(P.3-8)
SET TEMP Pre-Heater OFF/ 20 ~ 50°C
(OFF/ 68 ~ 122°F)
Sets heater conditions.
Print Heater OFF/ 20 ~ 50°C
(OFF/ 68 ~ 122°F)
Post Heater OFF/ 20 ~ 50°C
(OFF/ 68 ~ 122°F)
SET TIME STANDBY ( NONE
/ 0 ~ 90 min
10min unit)
OFF TIME ( NONE
/ 0 ~ 90 min
10min unit)
PRINT MODE
( P.3-12)
DRAFT Quality STD
/ FAST / FINE Sets a print quality level and printing
direction.
FINE Quality STD
/ FAST / FINE
SCAN DIRECTION Bi-D
/ Uni-D
LOGICAL SEEK ON
/ OFF
WhiteLay Print OFF
/ ON (LEVEL 1~3)
INK LAYERS ( P.3-24) 1
~ 9 Sets the number of layers in which
ink is to be applied.
DRYING TIME
( P.3-17)
SCAN 0.0
~ 19.9 sec Sets the time to wait for ink drying.
Draw. END 0
~ 999 sec
AUTO CUT ( P.3-24) ON / OFF
Cuts the media automatically after
printing.
PRE-FEED ( P.3-24) ON / OFF
Feeds the media back and forth
before printing.
When sticky media is used, select
ON.
MARGIN
( P.3-18)
LEFT -10 ~ 0
~ 85mm (1mm unit) Sets a non-printing area along the
right and left edges of the media.
RIGHT -10 ~ 0
~ 85mm (1mm unit)
COLOR PATTERN ( P.3-24) ON / OFF
Prints a color pattern for nozzle
missing check near the right edge of
the media.
REFRESH ( P.3-24) Level 0 (Refresh interval long
) ~ 3
(Refresh interval short)
Refreshes the print heads during
printing.
VACUUM ( P.3-24) OFF / STANDARD / WEAK /
Little WEAK / STRONG
Sets the absorbability of the media.
FeedSPEED LEVEL ( P.3-24)
*1
*1. When “ON” is set to “Select device” in “Setting of feeding and take up” of the machine setting, the feeding speed is limited on
max.150%.
10 ~ 100 ~ 200%
10% .............6mm/sec
100% ...........60mm/sec
200% .........120mm/sec
Changes the media feeding speed
in printing.
To Next Page
Loading...
